Overfender made in Japan.
If you want to secure it, use caulking material to attach it to the body.
[Installation] Rubber molding and tapping screws.
Projection Width: 0.4 inch (9 mm) wide from normal.
Quantity: 1 car.
Accessories: Dummy screw, rubber molding, tapping spike
■ Important information ■
Fits standard front and rear bumpers only.
To install on vehicles with factory or aftermarket aeros, please remove the aero or cut over the fender.
■ About Installation■
If the rear fender interferes with the sliding door upholstery, adjust the washer in the door fixing area.
The mounting surface should be degreased beforehand and reinforced with aero caulking agent or hot bond.
In addition, the caulking agent must be completely dried and cured before running.
Driving in poor dry conditions may cause them to fall off or break.
■About this product ■
There may be minor scratches on the surface of the product when releasing.
This product will disappear in the pre-treatment process, so it is not a quality issue.
